Visioneer 7400 Instrukcja Użytkownika Strona 1

Visioneer OneTouch 7400 USB MotorReplacementVisioneer OneTouch 7400 USB motor replacement.Written By: JenaINTRODUCTIONUse this guide to remove and rep

Step 1 — Outer CaseOn the bottom of the scanner,remove the screw at the top leftside.Step 2 Remove the rubber foot pad opposite the screw hole to exp

Step 3 Rotate the scanner so the screw hole is located on the top left hand side.Place the plastic opening tool between the top casement and bottom

Step 5 — MotorCarefully detach the wires from themotherboard, pulling slowly butfirmly.Step 6 Remove the four screws holding the motor in place.Note

To reassemble your device, follow these instructions in reverse order.This document was last generated on 2015-05-09 10:26:24 PM.Step 7Lift the motor